FAA Investigates Manufacturing Flaws in Boeing 787 Jetliners

The United States Federal Aviation Administration (FAA) on Sunday said it is investigating manufacturing flaws involved with some Boeing 787 Dreamliners but stated, it was too early to say whether it will require new inspections or not.

Boeing revealed that airlines operating with its 787 Dreamliners had removed eight jets from service as a result of two distinct manufacturing issues in fuselage sections in August.

The FAA said it could require inspections covering hundreds of 787 jetliners after production issues at one plant. a person briefed on the matter confirmed. The Wall Street Journal reported the potential inspections earlier, citing an internal government memo and people familiar with the matter.

“The agency continues to engage with Boeing,” the FAA said on Sunday. “It is too early to speculate about the nature or extent of any proposed Airworthiness Directives that might arise from the agency’s investigation.”

Boeing said, “The rest of the in-service fleet has been determined to meet limit load capability, and we are inspecting production airplanes to ensure any issues are addressed prior to delivery.”

Boeing said some aeroplanes have shims that are not the proper size, and some aeroplanes have areas that do not meet skin flatness specifications.

“Individually these issues, while not up to specifications, still meet limit load conditions. When combined in the same location however, they result in a condition that does not meet limit load requirements,” Boeing said.

In the memo dated August 31, Boeing told the FAA that it had manufactured some parts at its South Carolina facilities that failed to meet its standards, according to The Wall Street Journal.

Such a safety directive could potentially cover up to about 900 Dreamliners delivered since 2011, the person briefed on the matter confirmed.

It is not clear how many aeroplanes may have just one of the two reported issues.

Source: reuters.com

Leave a Reply

Your email address will not be published. Required fields are marked *